ATA: Sipura

This document refers to the steps involved in setting up a Linksys/Sipura 2000, 2100, 2102 or 3000 device.

Step 1

If you have a wireless router please follow instructions (B) if your network does not consist of a wireless router follow instruction (A).

(A) Open a browser and type in 192.168.0.1. This should prompt the Linksys Configuration Menu. If it does'nt please open your Control Panel click Network Connections, right click the Local Area Connection icon choose Status click the Support tab and direct your attention to the Default Gateway. Type the number that the Default Gateway represents into the address feild of a browser - this will prompt the Linksys Configuration Menu.

(B) Please pick up your phone and dial ****. You will get the Linksys Configuration Menu. It will prompt you to "enter your option followed by the pound key".

Now dial 7932# "and value followed by the pound key" Press 1# to enable. And then 1 again to save, this will take you back to the Linksys Configuration Menu.

Once back in the Linksys Configuration Menu dial 110#.

Please make note of the IP address that is read back to you.

Then proceed to a computer that is connected to the same router that the ATA is connected to.

Open a web browser and input the IP address you noted in the previous step into the address bar.

If successful, the Linksys Configuration Page should come up.

Step 2

Now that we are in the Linksys Configuration Menu direct your attention to the right side of the page. You will see two links; Admin andAdvanced. Please click Admin first, after waiting 5 seconds go ahead and click the Advanced link.

On the top of the page you will see a tab labelled Voice, click it and wait for the new tabs to load. Click the Line 1 tab afterwards.

Step 3

Now that we are in the Line 1 settings, please scroll about halfway down the page where you will find a group labelled Proxy and Registration. Here we are looking for three fields labelled Proxy, Outbound Proxy and Voice Mail Server, you will need to input your "proxy" inot these fields it will look something like this: 66.49.255.## (you can find out your proxy by logging into voip.wintegrated.com or check your Welcome Email). In the same general area you will find the fields labelled; Register Expires amd Proxy Fallback Intvl., the default settings is "3600' but this needs to be changed to "60".

Step 4

For the Proxy and Registration scroll down one menu box until you find Customer Information. Here we are looking for Display Name, User IDand Auth ID. Please make the correct changes by putting in your new Wintegrated number in all three fields (if you are porting your number please leave the number that you are porting). In the same general area you will need to find a field labelled Use Auth ID, make sure that you have selected "Yes".

Step 5

Proceed to the bottom of the page where you will notice the Submit All Changes button. Please click the button and wait for the ATA to reset. Pick up your phone and check for a dial tone, if you do not hear anything, power cycle your device by disconnecting it from power for 2 minutes then powering it back, this will ensure all changes have been registered properly.

Make sure that three of the four lights are green, if they arent please feel free to contact us.